 |  | 
  
dumble cs mod 2008
A complete
job in our shop. All the features listed, all wired, assembled, biased,
tested, ready to go. Built 100% by the Torres Engineering Master Techs
only.
Can, in some cases, be
done on that "dead circuit board" one you may have around (a lot of the
circuit boards die, leaving a good chassis and transformers, these can
be modded and fixed at the same time)
THE
MOD IS For:
 |
Blues
Deville |
 |
HotRod
Deville |
 |
Blues
Deluxe |
 |
Hotrod
Deluxe |
Any speaker setup (doesn't matter)
An all new Torres Designed complete point to point
super high performance rebuild of these amplifiers.
Features included:
All new Preamp and tone circuitry with that big bad tone that DUMBLE
amps have!! Full and rich, warm and punchy with definition and killer
tonality throughout.
All new channel switching HIGH GAIN two stage tube overdrive. No more
funky ugly tone, full, big overdrive with tons of sustain and best of
all, REALLY GREAT control with a drive and master control so much
better they should have new names!!
PLUS all rewired super clean "art in electronics" point to point
layout, all new Orange Drop Caps, all new power
supply with much lower noise and a huge bottom end boost from the
special Torres filter cap network.
Finally a TUBE DRIVEN TRANSFORMER reverb and a TUBE
DRIVEN active effects loop.
Your amp is boosted up to 6 preamp tubes and can use 5881's,
6L6, or KT66, or KT77, or EL34, or 6CA7 tubes - the conversion is done
during the mod.
Fully adjustable bias andTONS OF NEW technology,
already tested and ready to
go.
Additional features:
Includes all new tube sockets, all new pots.
NOTE: This is a very complex hand-wired amp unlike no other. There are
six tubes, an all new power supply, all new DC filament wiring, pots
and pot wiring, switches etc. A lot of stuff!!
it is not so much a mod as a completely new amp within your amp's
chassis.
tubeset link
|
FREE
SHIPPING ON ANY ORDER OVER $60.00 - FREE! (in the U.S. only
NOTICE - THE ORANGE
DROP CAPACITORS USED IN OUR KITS HAVE BEEN 100% DISCONTINUED BY THE
MANFACTURER FOR EVER. THEY WILL NEVER BE MADE IN THE U.S. AGAIN
HIGH
QUALITY Mallory Tubular Capacitors will be included in your kit
we
apolgize for this, but no one anywhere was warned or informed in any
way prior to discontinuance.
We can install any and all of our
kits in our custom workshop - email for info.
|
|