 |  | 
  
matched preamp tubes
These MATCHED EH 5751 tubes
are dual triodes where the A and B sides are closely matched for use in
the phase inverter or driver position of musical instrument amplifiers.
A single 12AX7/12AT7/12AY7/12AU7/5751 contains TWO circuits within the tube. These tubes are tested to find the INDIVIDUAL SINGLE TUBES in which these two circuits are MATCHED - 1 tube contains two circuits.
We found our suppliers could not provide us with enough high quality
Matched Preamp Tubes so we designed and built our own Tube
Matching Machine
accurate to .00002A measurement - super accurate.
Now we can provide matched high quality preamp tubes all the time.
The benefit of this tube in a guitar or bass amplifier is a matched
output section.
With a matched triode the upper and lower portions of the output
waveform will be much more equal.
When this waveform is not equal, differences are cancelled out in the
feedback loop of class A/B amplifiers and are noticed as a lack of
sustain or apparent "dead spots" in areas of the fret board.
At high levels at all frequencies, sustain will be improved.
This is even more critical in Class A amplifiers such as the Torres
Class A Models, Vox AC-30's, Matchless and other Class A amplifiers.
Improvements are heard in both Class A and Class AB amps.
Use the Matched 5751 tube in any application where a phase
inverter / driver 12AT7 (Slightly higher gain) or 12AX7 (slightly lower
gain) tube is specified.
The phase inverter / driver position of a guitar or bass amp is a
current driving position, and not part of the tone generation stage.
Using the 5751 in place of a 12AX7 will yield more clean headroom in
your output section. Using the 5751 in place of a 12AT7 will provide
more drive and a fuller tone. The tube types are interchangable without
any
adjustment required, so feel free to experiment!
They are a very noticeable improvement in tone in your amp!!
|
FREE
SHIPPING ON ANY ORDER OVER $60.00 - FREE! (in the U.S. only
NOTICE - THE ORANGE
DROP CAPACITORS USED IN OUR KITS HAVE BEEN 100% DISCONTINUED BY THE
MANFACTURER FOR EVER. THEY WILL NEVER BE MADE IN THE U.S. AGAIN
HIGH
QUALITY Mallory Tubular Capacitors will be included in your kit
we
apolgize for this, but no one anywhere was warned or informed in any
way prior to discontinuance.
We can install any and all of our
kits in our custom workshop - email for info.
|
|